Clean the surface well and free it from loose materials. Eliminate inconsistent parts, varnishes, grease, laitance, algae through sandblasting or brushing before applying Vetonit Bond 2.

Vetonit Bond 2 tends to experience “soft settlement” during storage; therefore, it is recommended to mix the material in the same container before use.

Follow the dilution ratio required for each type of premixed mortar.

Dilute 1 part Vetonit Bond 2 with 2 parts water. Mix thoroughly to obtain uniform consistency liquid.

Add the diluted Vetonit Bond 2 to pre-blended sand/ cement plaster, mortar, or other dry mixes. Mix for 3-4 min using a mechanical mixer at low speed. Allow the mixture to stand for 10 minutes, then mix again briefly to achieve a homogeneous, lump-free consistency.

Dilute 2 parts Vetonit Bond 2 with 1 part water. Mix thoroughly to obtain uniform consistency liquid.

Apply using a brush or spray directly onto the substrate. If using a hand pump, spray at a rate of 15 m2/liter. While the bonding agent is still wet, follow immediately by applying plaster, render, mortars or joint tapes, etc.

Note: Vetonit Bond 2 should remain tacky when applying top coat finishes.

Clean tools with water before it hardens. Clean hardened residuals mechanically only.