All new concrete surfaces must be cured for at least 28 days prior to the application of the primer.

For previously painted surfaces, remove old paint completely. The substrate should have sufficient strength and be free from unsound areas, pug holes, protrusions, and pops.

Ensure that the surface is clean, dry, and free from dust, oil, grease, salt, mold, and all forms of release agents/curing agents. A light sanding with suitable abrasive material is recommended before application. Any resulting dust or loose particles must be removed before application.

Apply one uniform coat of Vetoprime Décor over the properly prepared substrate for both interior and exterior applications. Ensure complete and consistent coverage of the surface, then allow the primer to dry completely before applying Vetotouch Graviatto AC.

Vetotouch Graviatto AC is supplied ready-to-use. Stir well before use with a flat paddle to achieve a homogeneous consistency. If thinning is required, add sweet water up to a maximum of 2 – 3% by volume and mix thoroughly (optional). Close the container when not in use.

Apply Vetotouch Graviatto AC uniformly over the prepared surface using a spray (hopper gun) or special trowel to achieve the desired rain-effect textured finish. Apply at the recommended thickness of approximately 0.60 mm and allow to dry completely.

Remove Vetotouch Graviatto AC from tools, equipment, and mixers with clean water before the initial set. Cured material can only be removed mechanically.