Vetotop Microcement Finish

Compatible substrates: product is applied on walls and floors coated with vetotop Microcement Base. Sanding maybe required depending on final appearance.

Prepared surfaces of microcement base shall be dry and clean from dust. Prime the surface with vetoprime Decor and allow to dry.

Microcement Finish: 24-26% by weight (6 - 6.5 L/25 kg bag). 

Mixing should be done with a drill mounted rapid set-type mixer. Always add clean potable water first. Mixing duration should last for 2 to 3 minutes to insure proper color and material dispersion within the mix. 

Mix enough quantity per area of application. Avoid creating cold joints.

Note: Conduct more than one trial to reach the desired finish. Ideal thickness: 1 to 2 mm. 

Using the trowel or squeegee, spread the microcement finish. Scrap over the layered material to remove any small lumps or lines. 

Allow to dry for 12-24 hours. Sanding can be done to remove any surface roughness or dried lines. 

Prime the surface with vetoprime Decore, allow to dry then apply another coat of vetotop Microcement Finish.

Allow to dry for 12-24 hours. Sanding can be done to remove any surface roughness or dried lines. 

The mirocement shall be left to dry completely (48 hours) prior to sealing it.

Cleaning all tools and equipment promptly with clean water.

The system is self curing. Allow to dry completely for at least 48 hours before sealing it.

Depending on service conditions : 

For light foot traffic: seal the surface with vetoseal UC773 or vetoseal AX774. 

For heavy traffic, and inside wet areas: seal the surface with vetoseal UC775 or vetotop UC370.

Regular cleaning with soapy water is recommended. Avoid using harsh chemicals or abrasive cleaners that may degrade the protective coating over time.