Apply the Marble Max on the substrate by using a suitable trowel depending on the tile size, then comb it in one direction, apply Marble Max on the tile backside using the flat edge of the trowel and do not comb (Back buttering). install the tile in its place and tap and press firmly (or use tile fixing vibrator) to ensure that the tile sitting on the substrate with the maximum coverage and contact between the tile back and the adhesive on the substrate.
Do not apply Marble Max on an area that takes more than 15 minutes to be tiled!
Useful practice to check the application efficiency is to remove a tile after application directly and observe the contact surface (adhesive on substrate and tile back), this can be done randomly as per the applicators point of view then reinstall again (this should be done always for the first Tile, so that the applicator will have an idea on how much adhesive needed for the best contact).
Recommended coverage to be 100 % externally and internally. The tile position can be adjusted without losing any adhesion for 15 minutes.
Allow the installed tiles to remain undisturbed for at least 24 hours. Marble Max must not rise between the tile joints higher than half of the thickness of the tiles. It is recommended to use Vetonit Tile Grout to fill the joint gaps after 2 days of tile installation.
Allow the tiles to dry for a week before proceeding to use as normal.
Note:
Low temperature and high air humidity will retard the curing and drying process and vis versa.
The best coverage is when it applied on flat surfaces.
For further information regarding the suitable substrates and tiles on which this product can be safely applied, please contact Saveto technical department.
