Saveto WP 1020

Submitted by webmaster on 10 July 2025

Substrate to be treated must be completely clean, structurally sound and mechanically keyed.
Remove all substrate coatings, defective renders, foreign matter, formwork treatment and other contaminate that may affect the bond adversely.
Substrates should be prepared by abrasive blasting or high pressure water treatment, don’t use aggressive method.
All mortar joints to be flush-pointed and repair active leaks with suitable concrete repair product.
Moisten the surface with clean water before application.
Put the liquid (Component A) in a suitable pot, then slowly add the powder (component B) to the liquid and mix using slow speed drill fitted with suitable paddle.
The product now is ready for application either by BRUSH or ROLLER.
Suitable brush will be 6 inches with nylon bristles.
First Coat: Apply the first coat of SAVETO WP 1020 at minimum thickness 1 mm by brush.
Spread the mix firmly onto the pre-dampened prepared substrate by brush.
Don’t spread the material too thinly.
When the material is coming to drag don’t add more water.
Allow at least an overnight cure before applying a second coat.
Second Coat: Dampen the first coat and remove excess moisture.
Brush the second coat of SAVETO WP 1020 at minimum thickness of 1 mm onto the substrate and finish at right angle to the previous coat.
Don’t mix more material than can be used in one hour.
If the mortar in the pot starts to harden, don’t add extra water.
Don’t apply SAVETO WP 1020 to frozen substrate or below 5º C.
Avoid application in direct sunlight.

High quality control system for raw material selection and testing products.
Exact mixing ratios (scales and weighing process) with controlled mixing method.
Excellent adhesion, bonds to porous and non- porous surface.
Flexible, high resistance to carbon dioxide and chloride on diffusion Outstanding wear and weather resistance and good chemical resistance to gasoline, diesel oil spillages, sodium hydroxide, calcium chloride.