Submitted by webmaster on 5 August 2025

Vetonit Putty WR

Water-resistant, high-quality, and cementitious premixed putty.

Vetonit Putty WR is composed of white cement, fine fillers, bonding chemicals, and high-performance additives. It is supplied as a dry powder in pre-weighed bags ready to use on-site, requiring only the addition of clean water to produce a cohesive mix. Vetonit Putty WR is a premium product and can be applied as a thin underlayment to repair undulations. It provides a fine surface finish that is ideal for subsequent applications of paint or decorative coatings. It is recommended to apply a thin layer of Vetonit Putty WR (1 - 3 mm).

Uses

  • Can be used to level minor surface undulations.
  • Can be applied in wet and dry conditions, as well as onto the walls and ceilings of bathrooms and kitchens.
  • It can be applied on surfaces that are plastered with Vetonit products and on gypsum boards.
  • It can be applied on smooth concrete and plastered surfaces and on pre-cast concrete surfaces.

Advantages

  • Factory-controlled pre-blend ensures consistently high quality.
  • Requires only the addition of water on-site at the time of usage.
  • Water-resistant.
  • Excellent adhesion on a variety of substrates.
  • Easy to apply as it requires minimum effort to achieve a superior finish.
  • Ideal for concrete and plastered walls and ceilings.
  • It achieves a smooth finish.
  • Suitable for humid and dry conditions.
  • mould resistance.

Usage Instructions

Make sure the surface is sound, clean, and free from loose material, grease, laitance, dirt-curing compounds, etc. before applying Vetonit Putty WR. Wet the entire surface with clean potable water. The surface should look damp at the time of the application.

For mechanical mixing, pour into the mixing container 1.9-2.1 liters of water for each 5kg, or 9.5 to 10.5 liters of water for each 25 kg bag of Vetonit Putty WR. Mix with a mechanical plaster mixer or with a low-speed electric drill fitted with a suitable paddle until a uniform, lump-free consistency is achieved.

Leave the mixed material to stand for 10 mins then briefly remix without adding water. Mix small batch quantities manually until a homogenous mix is achieved. When required, add 1 litre of Vetonit Bond 2 to the mixing water and adjust the water requirement for each 20 kg bag of Vetonit Putty WR accordingly. Follow the same mixing procedure as above.

Use the mixed material within 3 hours. Do not add water once the mixed filler mortar starts to harden.

Generally, it is recommended to apply Vetonit Putty WR in single or double coats. Apply Vetonit Putty WR to the substrate by pressing the putty firmly onto it. Use a flat trowel to level the material to a smooth finish. Apply a second coat if necessary once the first coat sets.

After applying Vetonit Putty WR, it is recommended to apply one coat of alkali-resistant primer followed by two coats of acrylic emulsion paint or other suitable coatings.

Vetonit Putty WR is self-curing, and it does not require water treatment. However, when using Vetonit Putty WR as a final finish, it is recommended to apply a single coat of Bond Pure. The bonding agent will act as a surface enhancer and a curing compound & it will naturally disintegrate with time.

Clean all tools with water immediately after finishing.

Downloads

Explore More Products

Vetocure XT425

Water Based Curing Compound.

Surface Treatments & Finishes

Vetoseal XW771

Silane-siloxane water repellent (Water-based).

Surface Treatments & Finishes

Vetorel XT420

Water based mold and form-work release agent.

Surface Treatments & Finishes