Submitted by webmaster on 10 September 2025

Vetonit Bond 2

Multipurpose, low viscosity bonding agent & admixture.

Vetonit Bond 2 is a single component polymer-based bonding agent for cementitious materials. It is water-based, specially formulated to enhance bonding properties and improve the mechanical strengths of cementitious mixes when incorporated with mixing water. Vetonit Bond 2 also reduces shrinkage cracks during the early stages of cement hardening by minimizing surface water loss in freshly applied mixes. Vetonit Bond 2 can be diluted on site with potable water for desired applications. Vetonit Bond 2 is ideal for use with Premix Plaster.

Surface Preparation

Clean the surface well and free it from loose materials. Eliminate inconsistent parts, varnishes, grease, laitance, algae through sandblasting or brushing before applying Vetonit Bond 2.

Application

Vetonit Bond 2 tends to experience “soft settlement” during storage; therefore, it is recommended to mix the material in the same container before use.

Follow the dilution ratio required for each type of premixed mortar.

As Admixture

Dilute 1 part Vetonit Bond 2 with 2 parts water. Mix thoroughly to obtain uniform consistency liquid.

Add the diluted Vetonit Bond 2 to pre-blended sand/ cement plaster, mortar, or other dry mixes. Mix for 3-4 min using a mechanical mixer at low speed. Allow the mixture to stand for 10 minutes, then mix again briefly to achieve a homogeneous, lump-free consistency.

As Bonding Agent

Dilute 2 parts Vetonit Bond 2 with 1 part water. Mix thoroughly to obtain uniform consistency liquid.

Apply using a brush or spray directly onto the substrate. If using a hand pump, spray at a rate of 15 m²/liter. While the bonding agent is still wet, follow immediately by applying plaster, render, mortars or joint tapes, etc.

Note: Vetonit Bond 2 should remain tacky when applying top coat finishes.